|
|
|
|
|
>>> Tools: Disconnect...Reconnect
>>> Ctrl+D
The Disconnect...Reconnect function is used to re-connect to a new logger. If a logger is disconnected the connection will time-out after 4 seconds. If you connect a different logger within 4 seconds, Omnilog does not relise that the loggers have been changed. If this occures, Omnilog will treat the new logger as if it was the original connected logger. This may well cause Omnilog errors. If you are changing loggers quickly, use the Disconnect...Reconnect function to disconnect from the old logger and connect to the new logger.