|
|
|
|
|
The OmniLog Data Management software is available both on CD ROM and via Internet . Installation procedures are as follows:
Insert the CD ROM into your drive
If the computer is set to Autorun CD's a Menu screen will be displayed
If the computer is not set Autorun CD's run the setup.bat file from the top folder on the CD ROM
Select "Install Omnilog" from the Menu
Follow the "General Installation Procedure" below
The OmniLog Data Management installation file can be downloaded from
http://www.trutrack.com - select Software - then Omnilog Download
Click on the download hyperlink and specify a folder on your computer for the downloaded file.
The downloaded file will be omni_install.exe
Once this file has finished downloading, run it from Windows Explorer.
Follow the "General Installation Procedure" below
The Setup splash screen appears and after a few seconds the Setup Wizard that will guide you through the rest of the installation appears.
It is recommended that you accept the defaults suggested by the Setup program.
The first screen asks you to close any open applications and gives some copyright information.
Click Continue
The second screen asks for your name and organisation
Click OK
This second screen will be shown again for you to check your name and organisation details
Click OK
The Third screen will allow you to change the default location of the installed application. By default, the application will be installed in C:\Program Files\omni. If you would like the application installed in a different folder you can specify this folder with the Change Folder button.
Click OK
The forth screen tells you that Setup is now ready to start the installation
Click on the Button to start the installation
The Fifth screen will allow you to change the default Program Group that the Omnilog software will be installed under.
Click OK
The software will now be installed
The final screen will tell you if the installation has been successful. If the installation has failed for any reason, this screen will display and error message explaining the reason for the failure.
Click OK